Orthogonal cutting mechanics of maple: modeling a solid wood-cutting process

Abstract

The experimental results of orthogonal cutting of maple and the modeling of the cutting mechanics are presented. The tool cutting forces were measured for different feed rates. A set of equations relating the tangential and feed forces to the tool edge width and feed rate (chip thickness) to calculate the chip and edge cutting force coefficients was developed. Then the chip force and edge force coefficients were calculated from experimentally obtained cutting forces and were plotted in a polar-coordinate system with respect to the fiber orientation of the maple disk. The polar-coordinate presentation of the cutting force results and the calculated cutting force coefficients provides an excellent visual appreciation of the relation between the cutting forces and the wood fiber orientation. Chips were also collected from various sectors of the wood disk. This analysis further identified the effects of fiber orientation and cutting forces on the types of chip formed and hence the cutting mechanics involved. By applying the calculated cutting coefficients for each tool orientation (in respect to the grain) it is possible to predict the feed and tangential forces for any feed rates. There is good agreement between the predicted and measured cutting forces.