[A & I plus PDF only]
COPYRIGHT: © Author(s) 2014. This work is distributed under the Creative Commons Attribution 3.0 License.
You have requested "on-the-fly" machine translation of selected content from our databases. This functionality is provided solely for your convenience and is in no way intended to replace human translation. Show full disclaimer
Neither ProQuest nor its licensors make any representations or warranties with respect to the translations. The translations are automatically generated "AS IS" and "AS AVAILABLE" and are not retained in our systems. PROQUEST AND ITS LICENSORS SPECIFICALLY DISCLAIM ANY AND ALL EXPRESS OR IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION, ANY WARRANTIES FOR AVAILABILITY, ACCURACY, TIMELINESS, COMPLETENESS, NON-INFRINGMENT, MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Your use of the translations is subject to all use restrictions contained in your Electronic Products License Agreement and by using the translation functionality you agree to forgo any and all claims against ProQuest or its licensors for your use of the translation functionality and any output derived there from. Hide full disclaimer
Copyright Copernicus GmbH 2014
Abstract
A new methodology for the determination of the changes due to hygroscopic growth with relative humidity of the number size distribution and optical properties of polydispersed aerosols is described. This method uses the simulation chamber CESAM where the hygroscopic properties of polydispersed aerosol particles can be investigated in situ by exposing them to RH ranging from 0 to 100% for approximately 1 h. In situ humidification is used to provide simultaneous information on the RH-dependence of the particle size and the corresponding scattering coefficient (σscat ), and that for the entire size distribution. Optical closure studies, based on integrated nephelometer and aethalometer measurements, Mie scattering calculations and measured particle size distributions, can therefore be performed to yield derived parameters such as the complex refractive index (CRI) at λ = 525 nm. The CRI can also be retrieved in the visible spectrum by combining differential mobility analyzer (DMA) and white light aerosol spectrometer (Palas Welas®) measurements.
We have applied this methodology to ammonium sulfate particles, which have well known optical and hygroscopic properties. The CRI obtained from the two methods (1.54-1.57) compared favourably to each other and are also in reasonable agreement with the literature values. The particle's growth was compared to values obtained for one selected size of particles (150 nm) with a H-TDMA and the effect of the residence time for particles humidification was investigated. When the humidification was performed in the chamber for a few minutes, a continuous increase of the ammonium sulfate particle's size and σscat was observed from RH values as low as 30% RH. Comparison of the measured and modelled values based on Köhler and Mie theories shows that layers of water are adsorbed on ammonium sulfate particles below the deliquescence point. In contradiction, the particle's growth reported with H-TDMAs showed a prompt deliquescence of ammonium sulfate particles with no continuous growth in size at low RH. These findings highlight the need to allow sufficient time for particle-water vapour equilibrium in investigating the aerosols hygroscopic properties. H-TDMA instruments induce limited residence time for humidification and seem to be insufficient for water adsorption on ammonium sulfate particles.
You have requested "on-the-fly" machine translation of selected content from our databases. This functionality is provided solely for your convenience and is in no way intended to replace human translation. Show full disclaimer
Neither ProQuest nor its licensors make any representations or warranties with respect to the translations. The translations are automatically generated "AS IS" and "AS AVAILABLE" and are not retained in our systems. PROQUEST AND ITS LICENSORS SPECIFICALLY DISCLAIM ANY AND ALL EXPRESS OR IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION, ANY WARRANTIES FOR AVAILABILITY, ACCURACY, TIMELINESS, COMPLETENESS, NON-INFRINGMENT, MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Your use of the translations is subject to all use restrictions contained in your Electronic Products License Agreement and by using the translation functionality you agree to forgo any and all claims against ProQuest or its licensors for your use of the translation functionality and any output derived there from. Hide full disclaimer