It appears you don't have support to open PDFs in this web browser. To view this file, Open with your PDF reader
Abstract
Atom probe tomography (APT) and scanning transmission electron microscopy (STEM) techniques were used to probe the long-time thermal stability of nm-scale Mn-Ni-Si precipitates (MNSPs) formed in intermediate and high Ni reactor pressure vessel steels under high fluence neutron irradiation at ≈320 °C. Post irradiation annealing (PIA) at 425 °C for up to 57 weeks was used to determine if the MNSPs are: (a) non-equilibrium solute clusters formed and sustained by radiation induced segregation (RIS); or, (b) equilibrium G or Γ2 phases, that precipitate at accelerated rates due to radiation enhanced diffusion (RED). Note the latter is consistent with both thermodynamic models and x-ray diffraction (XRD) measurements. Both the experimental and an independently calibrated cluster dynamics (CD) model results show that the stability of the MNSPs is very sensitive to the alloy Ni and, to a lesser extent, Mn content. Thus, a small fraction of the largest MNSPs in the high Ni steel persist, and begin to coarsen at long times. These results suggest that the MNSPs remain a stable phase, even at 105 °C higher than they formed at, thus are most certainly equilibrium phases at much lower service relevant temperatures of ≈290 °C.
You have requested "on-the-fly" machine translation of selected content from our databases. This functionality is provided solely for your convenience and is in no way intended to replace human translation. Show full disclaimer
Neither ProQuest nor its licensors make any representations or warranties with respect to the translations. The translations are automatically generated "AS IS" and "AS AVAILABLE" and are not retained in our systems. PROQUEST AND ITS LICENSORS SPECIFICALLY DISCLAIM ANY AND ALL EXPRESS OR IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION, ANY WARRANTIES FOR AVAILABILITY, ACCURACY, TIMELINESS, COMPLETENESS, NON-INFRINGMENT, MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Your use of the translations is subject to all use restrictions contained in your Electronic Products License Agreement and by using the translation functionality you agree to forgo any and all claims against ProQuest or its licensors for your use of the translation functionality and any output derived there from. Hide full disclaimer
Details
; Yamamoto, T 1 ; Odette, G R 1 1 Materials Department, University of California, Santa Barbara, CA, USA
2 Materials Department, University of California, Santa Barbara, CA, USA; Intel Corporation, Hillsboro, OR, USA
3 Department of Materials Science and Engineering Department, University of Wisconsin, Madison, WI, USA; Materials Science and Engineering Department, Ohio State University, Columbus, OH, USA
4 Materials Science and Technology Division, Oak Ridge National Laboratory, Oak Ridge, TN, USA
5 Department of Materials Science and Engineering Department, University of Wisconsin, Madison, WI, USA




