Correction: Białobrzeska, B.; Jasiński, R. Resistance to Abrasive Wear with Regards to Mechanical Properties Using Low-Alloy Cast Steels Examined with the Use of a Dry Sand/Rubber Wheel Tester. Materials 2023, 16, 3052

In the original publication [1], there were mistakes in Figure 11b as published including Y scale, value of melt 6 under 200 °C and relationship between melt 1 and melt 2 under all temperature conditions. The corrected Figure 11b appears below. The authors state that the scientific conclusions are unaffected. This correction was approved by the Academic Editor. The original publication has also been updated.

Footnotes

Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content.

Figure

Figure 11. Hardness (a) and yield point (b) of the analyzed alloys after quenching and tempering at 200, 400 and 600 °C.

Reference

1. Białobrzeska, B.; Jasiński, R. Resistance to Abrasive Wear with Regards to Mechanical Properties Using Low-Alloy Cast Steels Examined with the Use of a Dry Sand/Rubber Wheel Tester. Materials; 2023; 16, 3052. [DOI: https://dx.doi.org/10.3390/ma16083052] [PubMed: https://www.ncbi.nlm.nih.gov/pubmed/37109887]