Correction: Fernández Blanco et al. A Photonic Immunosensor Detection Method for Viable and Non-Viable E. coli in Water Samples. Microorganisms 2024, 12, 1328

In the original publication [1], Figure 2 has been replaced by a new reference [53]. The citation [53] has now been inserted in paragraphs 4, 6 and 7 of Section 2.5. The rest of the figures and references have been renumbered accordingly.

The newly added reference [53] is as follows:

Fernández Blanco, A.; Hernández Pérez, M.; Moreno Trigos, Y.; García-Hernández, J. Specific and Simultaneous Detection of E. coli O157:H7 and Shiga-like Toxins Using a Label-Free Photonic Immunosensor. Photonics 2024, 11, 374.

There was a mistake in the original Figure 4A,B as published. The corrected Figure 4A,B (now Figure 3A,B) appear below.

The authors state that the scientific conclusions are unaffected. This correction was approved by the Academic Editor. The original publication has also been updated.

Footnotes

Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content.

Figure

Figure 3 Validation calibration curves for E. coli antigens. These curves are divided into three panels. (A) Relationship between the resonance shift and the concentration of pure E. coli CECT 425 strain in a controlled environment. (B) Calibration curve of E. coli CECT 425 spiked in drinking water samples. (C) Calibration curve of naturally contaminated drinking water samples with E. coli. The Limit of Detection (LoD) and Limit of Quantification (LoQ) were computed to specify the minimum concentration of the analyte that the biosensor is capable of reliably detecting and quantifying. The Upper Limit of Quantification (ULOQ) is established in accordance with analysis requirements. In order to ascertain s0, no fewer than six determinations of samples at the calculated breakpoint concentration were performed. The concentration data for E. coli strains and both spiked and naturally contaminated samples were sourced from Tables S1 and S2 (Supplementary information attached file), with resonance measured in picometers (pm) using a laboratory setup reader, as detailed in Section 2.

References

Reference

1. Fernández Blanco, A.; Moreno, Y.; García-Hernández, J.; Hernández, M. A Photonic Immunosensor Detection Method for Viable and Non-Viable E. coli in Water Samples. Microorganisms; 2024; 12, 1328. [DOI: https://dx.doi.org/10.3390/microorganisms12071328] [PubMed: https://www.ncbi.nlm.nih.gov/pubmed/39065096]